Skimmer 17,5 l standard neck, for foil (209x144 opening)

Product detailed description

Quality skimmer from Spain for sturdy in-ground pools made of plastic, lost formwork, foil and laminate. Also applicable for above ground pools, but due to its dimensions it already stands out quite a bit.

Warning this skimmer is shorter and the body may not come out past the lost formwork, it is important to measure. In general, it is applicable where you use a formwork of max 10cm width, which is not enough. If you leave out the two lost formers underneath, then the skimmer can be finished off.

The skimmer is made of high quality plastic and the screws have brass counter-nuts which will resist corrosion for years and there is no cracking of the plastic.

For flow rates up to 16m3/h.

Made of ABS plastic with UV stabilisation.

Connecting the skimmer to the filtration system

Below the skimmer has two outlets, you choose one and  connect with a 2" nipple or screwing. You plug the other one with the enclosed plug and gasket.Then you connect the 50mm pipe and proceed to filtration.

Attaching the skimmer to the pool wall

On the lost formwork you will only concrete the neck, the skimmer body will stick out behind the pool. You need to leave out the larger hole (40cm wide, 50cm high) and concrete the skimmer. It is recommended to tape the threads before concreting to prevent mess from getting in. Concrete the skimmer after it has been removed - without gaskets, flanges, etc.

Skimmer Installation - Instructions

The skimmer comes to be placed in the top of the pool, near the filtration. Always install the skimmer, if you can, opposite the return nozzle to ensure circulation of the water. The skimmer collects debris from the pool surface, so it is imperative that it is placed at the top, the level is then about half or top third of the skimmer.

HOW TO CONNECT THE PUMP TO THE POOL:

In order to use this feature, it is necessary to close the bottom outlet valve so that all the motor thrust goes through the skimmer. Then the suction cover - disc is placed on the basket and fixed by the paws. As a final step, the hose is attached to the suction cover. If the pool has more than one skimmer, all but one of them, which will be used to connect the vacuum cleaner, must be closed.